Panasonic ES‑RT67 Instrucciones De Funcionamiento página 15

3
3
While pressing and
holding the trimming
height switch button, move
the comb vertically to the
desired trimming length
(between 1 mm and 7 mm).
Trimming
height (mm) 1.0 2.5 4.0 5.5 7.0
(approx.)
Indicator 1.0 2.5 4.0 5.5 7.0
• Actual hair length will be a little
longer than the height you set.
4
4
Lightly push the comb
attachment to ensure that
it has locked into place.
5
5
Turn the shaver on, bring the comb of the
comb attachment into contact with the skin,
and cut the beard by moving the trimmer back
against the flow of the beard.
Notes
• Be careful not to cut your hand on the blade when
attaching and removing the comb attachment.
• Do not use with shaving creams applied or when the beard
is wet. Wet beard can stick to the skin or clump making it
difficult for the blade to cut.
• Comb beard and sideburns before trimming.
• Hair trimmings may collect inside the comb attachment
when a large volume of beard is cut, so discard hair
trimmings after each use.
• If the comb attachment is not attached properly, it may
become loose during use resulting in excessive cutting.
Reading lamps when using
During use
ES-RT67
Approximate amount of
battery charge is displayed
as 20 – 100.
• It turns off after
approximately 5 seconds.
ES-RT47/ES-RT37
All lamps disappear while
using.
15