Manual Operation - Emerson Warm Tiles ES Manual Del Usuario

9.2 Manual Operation

1
4
2 3
6
5
7
8
9
10
11
Note: The temperature set
manually on the home screen
is a temporary setting. The
manual override setting will be
automatically canceled at the
beginning of the next event in
the Scheduled Operation.
PAGE 26
All Rights Reserved. Used under license by EasyHeat Inc.
During Scheduled Operation, you can use the arrow buttons on the home screen to
override the programmed target temperature/setpoint for Scheduled Operation and
to set the required temperature manually.
Use the "Arrow Up" or "Arrow Down" button to select the required temperature.
The "Return to Schedule" button will then appear on the home screen – you
should tap this button if you want to end Manual Operation and return to Scheduled
Operation. You can also choose "Adjust...".
1. Day and time.
2. Measured temperature.
3. Heating indicator. If visible, the underfloor heating system is currently active.
4. Tap here to access the menu.
5. Current target temperature/setpoint.
6. Tap here to increase the temperature.
7. Tap here to decrease the temperature.
8. Current thermostat operating mode.
9. Information on the next thermostat behavior change.
10. Tap here to adjust the length of time the displayed target temperature/setpoint is
to remain valid.
11. Tap here to return to Scheduled Operation. Available only when the thermostat is
operated manually.
<
Contents
>