Accessing a parameter
1.
Press PROGRAM
PROGRAM mode.
2.
Either use the ARROW keys
different parameter, or:
3.
Press DISPLAY
field.
4.
Key in the desired parameter number followed by
ENTER
.
5.
For example: press
6.
The LCD displays the new parameter number and
value.
Changing a Parameter Value
Notes:
• Security must be disabled to enable programming: set P000 to the Unlocked Value stored
in P069. (A remote master can still change configuration, if P799 is set to allow this.)
• Invalid entries will be rejected or limited.
• CLEAR
can be used to clear the field.
1.
Key in the new value.
2.
Press ENTER
Parameter Reset to Factory Default
1.
Scroll to the parameter or enter its address.
2.
Press CLEAR
Master Reset (P999)
Returns all parameters except P000 and P069 to default settings. (The learned TVT curve is not
lost.)
1.
Press PROGRAM
2.
Press DISPLAY
3.
Key in 999.
4.
Press CLEAR
reset. The LCD displays C.ALL.
5.
Reset complete. (Reset takes several seconds to complete.)
A5E32168031
then DISPLAY
to scroll to a
to open the Parameter Number
then
.
to set the value.
then ENTER
. The value returns to the default setting.
then DISPLAY
,
to open parameter fields.
then ENTER
, to Clear All and initiate
SITRANS Probe LU (HART) – QUICK START MANUAL
, to activate
to activate PROGRAM mode.
PROGRAM Icon
Parameter Number
Parameter Value
current value
Page EN-9