Electronic Equipment - EdilKamin NANCY Instalación Uso Y Mantenimiento

LEONARDO is a combustion safety and control system which allows optimal performance in all
®
conditions than s to two sensors measuring the pressure level in the combustion chamber and smo e
temperature.
he detection of and subsequent optimisation of these two parameters is continuous in order to correct
operation anomalies in real time.
he LEONARDO system offers constant combustion, automatically regulating the draft based on the
®
characteristics of the chimney ue (bends, length, shape, diameter, etc..) and environmental conditions
(wind, humidity, atmospheric pressure, installations at high altitude, etc.).
he standards for installation must be respected.
LEONARDO ® system is also able to recognise the type of pellets and automatically d ust the ow mo-
ment by moment to ensure the required level of combustion.
ELECTRONIC CIRCUIT BOARD
ventilation
SERIAL PORT
he Dealer can install an optional on the A
off (e.g. telephone remote, local thermostat), located at the rear oh the stove. Can be connected via
special optional trestle (code
BACKUP BATTERY
A bac up battery is found on the control board ( - olt CR
product defect, but normal wear and tear) is indicated with the words "Battery chec ". For more detai-
led information, please contact the DEALER who has performed the rst st ignition.
ROOM TEMPERATURE SENSOR
An outlet for the metre-long room temperature cable is provided on the bac of the stove. he sen-
sor, which will be attached to the wall using the brac et provided, is wired onto the end of the cable.

ELECTRONIC EQUIPMENT

M
N
F
R
bac up
battery
lithium
CR
D A
Smo e expulsion motor
F
SCRE
outlet for controlling the process of switching on and
). he serial port is located inside the coating on the left side.
G
L
ow sensor
smo e rpm
sensor air
ambient (optional)
P
B
C
ingnition element
vac power supply
battery). Its failure (not considered a
- 24
-
H
acuum gauge
Reading
points