Display Panel - Candy CMDN 182 EU Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 49
INTRODUCTION
Before use
Please read these instructions and the Safety
guidelines on page 1 carefully before using your new
Freezer. The Freezer is for indoor, domestic use only.
No
Description
1
2
3
Bottle Rack
4
Refrigerator Glass Shelf
5
Salad Crisper
6
Upper Freezer Drawer
7
Bottom Freezer Drawer
8
Adjustable Foot
INSTALLATION
Location
When selecting a position for your Freezer you should
make sure the floor is flat and firm, and the room is
well ventilated with an average room temperature of
between 16℃ and 38℃. Avoid locating your Freezer
near a heat source, eg, cooker, boiler or radiator. Also
avoid direct sunlight in out-buildings or sun lounges. If
you are placing your Freezer in an out-building such as
a garage or annex ensure that the Freezer is placed
above the damp course, otherwise condensation will
occur on the Freezer cabinet. Never place the Freezer
in a wall recessed or into fitted cabinets or fumiture
when your Freezer is working, the grille at the back
may become hot and the sides warm. It must
therefore be installed so that the back of the Freezer
has at least 9cm(31/2") of free space and the sides
have 3cm(3/4"). Do not drape the Freezer with any
covering.
Light
Egg Tray
Leveling the Freezer
If the Freezer is not level, the door and magnetic seal
alignment will be affected and may cause you Freezer
to work incorrectly. Once the Freezer is placed in its
final location, adjust the leveling feet at the front by
turning them.
Cleaning before use
Wipe the inside of the Freezer with a weak solution of
bicarbonate of soda. Then rinse with warm water
using a damp sponge or cloth. Wash the baskets and
shelves in warm soapy water and dry completely
before replacing in the Freezer. The external parts of
the Freezer can be cleaned with wax polish. See page
9 for more details on cleaning.
Before plugging in YOU MUST
Check that you have a socket which is compatible with
the plug supplied with the Freezer. If not see the
section called ELECTRICAL INFORMATION .
Before switching on!
DO NOT SWITCH ON UNTIL FOUR HOURS AFTER
MOVING THE FREEZER.
The coolant fluid needs time to settle. If the appliance
is switched off at any time, wait 30 minutes before
switching back on to allow the coolant fluid to settle.
Before filling your Freezer
Before storing foods in your Freezer, turn the Freezer
on and wait for 24 hours, to make sure it is working
properly and to allow the Freezer to fail to the correct
temperature.
START
1. Keys

1.1 Display panel

27

Publicidad

Tabla de contenido
loading

Tabla de contenido