Cleaning - De Dietrich DTE714X Manual De Instalación Y Utilizacion

INSTRUCTIONS FOR THE USER
- After use the electric plate remains very hot for
a prolonged period of time, do not tuch it and do
not place any object on top of the plate.
- For a good preservation, the electric plate must
be thoroughly cleaned with appropriate cleaning
products which are readly available.
KNOB
SETTING
0
1 Very low
2
3
4 Medium
5 Strong
6 Very strong

CLEANING

Before any operation, disconnect the appliance
from the electric grid.
It is advisable to clean the appliance when it is
cold.
Enamelled parts
The enamelled parts must be washed with a
sponge and soapy water or with a light detergent.
Do not use abrasive or corrosive products.
Do not leave substances, such as lemon or tomato
juice, salt water, vinegar, coffee and milk on the
enamelled surfaces for a long time.
Stainless steel an alluminum parts
Stainless steel can be stained if it remains in
contact with highly calcareous water or aggressive
detergents for an extended period of time.
The stainless steel parts should also be cleaned
with soapy water and then dried with a soft cloth.
HEAT
Off
To heat small quantities of liquids.
Heating medium quantities of liquid, to prepare sauces and
Low
creams requiring long cooking.
Mild To defrost frozen foods, cook stews, at to below boiling point.
For foods which require boiling point, delicate meat and fi sh.
For roasting, grilling, stews.
To boil large quantities of liquid, to fry.
5
NB.: When operating for the first time, it is
necessary to eliminate any humidity or oil
which may accumulated around the electric
elements of the plate by operating the electric
plate on its lowest setting (1) for about 30
minutes.
TYPE OF COOKING
Burners and racks
These parts can be removed to make cleaning
easier.
The burners must be washed with a sponge and
soapy water or with a light detergent, wiped well
and placed in their housing perfectly.
Make sure that the flame-dividing ducts are not
clogged.
Check that the feeler of the safety valve and the
start-up electrode are always perfectly cleaned, so
as to ensure an optimum operation.
The racks can be washed in the dishwasher.
Gas taps
The possible lubrication of the taps must be carried
out by specialized personnel, exclusively.
In case of hardening or malfunctions in the gas
taps, apply to the Customer Service.