Jacuzzi folia Manual De Instalación página 6

(Twist Jet): insert the nozzle in the outlet body. Then install
the cover so that the pin fits into the centre hole of the nozzle.
(Hydro Jet): insert the plastic spring in the outlet body. Then
set the nozzle on and install the cover.
Make sure that the grooves under the cover are inserted into the
corresponding notches in the outlet unit.
i
I
( 8 ) In models with an air bubble generator (blower), press
the covers into the jets on the bottom of the tub.
I Run a hydromassage cycle, making sure that there is no
leakage, particularly in the hydraulic connections and drain.
INSTALLING THE PANELS
i
I (
9
) Fasten the elastic metallic supports (L), using the two self-
threading screws, to the inserts (N) under the edge of the tub.
i
I (
10
) Click the springs (P) onto the legs at the corners of
the tub and make them slide up until they touch the top, push-
ing them from both sides so that they settle inside the tub
edge.Insert the ring (R) into the groove of the leg.
i
I (
11, 12, 13, 14, 15
pending on the model to be installed. Make sure that the brackets
are as parallel as possible with the edge of the tub (dotted line in
figure).
Adjust their height with the ring nut (Y) and their distance from
the projection of the tub edge.
Tighten the nut (W).
Note: the height with respect to the edge of the bath must be
i
measured from the slot (
Rectangular tubs
i
I (
16
) If side panels are to be installed, insert them between the
springs (P) and the tub edge, lift it until the holes coincide with
the slots of the brackets (Z) and fasten them with the self-thread-
ing screws provided and the corresponding plastic washers.
In the Invita model, use holes "a-b" to install the panel on the left
and holes "c-d" to mount it on the right.
All models:
i
I (
16
) Place the front panel near the tub and insert it between
the centre springs (L), the side springs (P) and the tub edge. For
rectangular models, also insert the side panel if included.
i
I (
16 ) Install the white caps supplied onto the screws (U).
FINISHING TOUCHES
i
I (
17
) Place the headrest from the back side.
i
I (
18
) Carefully apply silicone all along the rim, to the points
that will rest against the wall.
) Adjust the brackets (Z) as shown, de-
11, 12, 13, 14 ).
GENERAL WARNINGS
JACUZZI EUROPE S.p.A. declines all responsibility in the follow-
ing cases:
If installation is carried out by unqualified personnel and/or per-
sonnel unauthorized to carry out installation.
If the norms and legal provisions, regarding the electric systems
of buildings, in force in the country in which installation is carried
out are not complied with.
If the instructions for installation and maintenance contained in this
manual are not followed.
If unsuitable and/or uncertified materials are used for installation.
If incorrect operations are carried out that reduce the level of pro-
tection against water jets or change the protection against elec-
tric shocks by direct or indirect contact, or generate conditions of
abnormal insulation, current dispersion or overheating.
If any components or parts of the appliance are altered in relation
to the original state when supplied, releasing the Manufacturer from
any liability.
If the appliance is repaired by unauthorised personnel or if spare
parts are used other than the original ones supplied by Jacuzzi Eu-
rope S.p.A.
6