Atag CM4411 Manual De Instrucciones página 124

USE
EN 16
• If the fi lling chute is blocked (due to damp in the appliance or
because more than 2 measuring spoons have been inserted), use a
knife or spoon handle to push the ground coffee down (fi g. 14).
Next remove the brewing unit and clean it together with the coffee
machine as described in (see "Cleaning the coffee machine" on
page 21) and (see "Cleaning the brewing unit" on page 21).
• To return to the mode for coffee beans after making the coffee, turn
the "coffee strength/preground coffee" knob to any coffee strength
setting (this re-enables the coffee grinding mill).
14
Preparing hot water
Hot water can be used to warm up cups and to make hot drinks, such
as tea or packet soups.
Warning! Escaping hot water can lead to scalds! Only activate the
hot water nozzle when there is a receptacle underneath it.
1. Put the hot water nozzle in place (fi g. 15).
2. Place a container underneath the hot water nozzle (fi g. 15).
3. Press the "hot water" button. Hot water is dispensed; the display
shows HOT WATER. Once the programmed amount of hot water is
dispensed, dispensing stops automatically.
For a few seconds the display shows PLEASE WAIT.... After that the
appliance is ready to make coffee again and the last selected coffee
setting appears on the display.
15
Making cappuccino or hot milk
Rinse the special milk container under the tap when you are about to
use it for the fi rst time.
1. Unfasten the lid of the milk container with a slight clockwise turn
and remove it.
2. Fill the container with suffi cient milk (preferably skimmed or semi-
skimmed milk at fridge temperature (about 5 °C) should be used).
Do not go over the MAX line engraved on the container handle
(comes to about 1000 ml).