Atag CM4411 Manual De Instrucciones página 135

MAINTENANCE
Make sure that any splashes from the descaling product do not
come into contact with surfaces that are sensitive to acids, such
as marble, limestone and ceramic.
5. Put a container with a capacity of at least 1.5 litres underneath the
hot water nozzle (see fi g. 2 on page 9).
6. Press the MENU button. The display shows DESCALING.The
descaling liquid runs out of the hot water nozzle.
The descaling program automatically goes through a serie of rinses
and pauses to remove limescale deposits from the inside of the
coffee machine.
After about 30 minutes the water tank is empty and the top line of
the display alternates between DESCALE COMPLETE and PRESS
MENU KEY.
7. Press the MENU button. The display shows RINSING, FILL TANK.
The appliance is now ready for a rinsing process with clean water.
8. Empty the container under the hot water nozzle and put it back
under the hot water nozzle.
9. Take out the water tank and fi ll it with clean water.
10. Put the water tank back in place. The display shows: RINSING,
PRESS MENU KEY.
11. Press the MENU button. A rinsing process takes place with clean
water and the rinsing water runs out of the hot water nozzle.After
a few minutes the water tank is empty and the display shows
RINSING COMPLETE, PRESS MENU KEY.
12. Press the MENU button. The display shows FILL TANK!
13. Take out the water tank, fi ll it with clean water and put it back in
place.
The appliance is now ready for use again and is back to the last
coffee mode selected.
If the descaling cycle is interrupted before completion, the appliance
continues to display the descale message and the program must be
started again from the beginning.
Failure to descale the appliance invalidates the guarantee.
EN 27