Environmental Protection/Disposal - Narex ENP 20 E Manual De Instrucciones

Environmental Protection/
Disposal
Power tools, accessories and packaging should
be sorted for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools
into household waste!
According to the European Directive
2002/96/EC on waste electrical and electronic
equipment and its incorporation into national
law, power tools that are no longer suitable for
use must be separately collected and sent for
recovery in an environmental-friendly manner.
Storage
The unit should be stored in a dry place where it
is protected against freezing.
Maintenance
� Air vents (7) of engine cover must not get
plugged.
� Cable may only be replaced in a professional
electric shop, which is authorized to carry out
works of such nature.
� Review the length of brushes after ca
100 hours of operation. Any brushes shorter
than 5 mm should be replaced for new ones.
When replacing the brushes, make sure
these are not turned or mixed up.
� Exchange the lubrication oil in the gearbox
and bearings after ca 100 hours of operation.
To preserve the respective protection
class, the machine must be checked in
terms of safety, therefore these works
need to be performed in a professional
electric shop, which is authorized to carry
out works of such nature.
Service
See enclosed sheet.
Guarantee
Our equipment is under warranty for at least
12 months with regard to material or production
faults in accordance with national legislation. In
the EU countries, the warranty period for ex-
clusively private use is 24 months (an invoice or
delivery note is required as proof of purchase).
Damage resulting from, in particular, normal
wear and tear, overloading, improper handling,
or caused by the user or other damage caused
by not following the operating instructions, or
any fault acknowledged at the time of purchase,
is not covered by the warranty. Complaints will
only be acknowledged if the equipment has not
been dismantled before being sent back to the
suppliers or to an authorised NAREX customer
support workshop. Store the operating instruc-
tions, safety notes, spare parts list and proof of
purchase in a safe place. In addition, the manu-
facturer's current warranty conditions apply.
Note
We reserve the right to make changes to the
technical data contained in this information as a
result of ongoing research and development
work.
Noise level and vibrations
Values measured were in accordance with
EN 60 745.
The acoustic pressure level: 88 dB (A).
The acoustic output level: 101 dB (A).
Use noise-suppressing protective aids.
Weighed vibration level acting on hands and
arms: 2.5 m/s
2
Inaccuracy of measurement K=2 dB (A).
Declarations of conformity
We declare under our sole responsibility that
this product is in conformity with the following
standards or standardization documents:
EN 60 745-1, EN 60 745-2-8, EN 55 014-1,
EN 55 014-2, EN 61 000-3-2, EN 61 000-3-3
according to the provisions of the regulations
89/336/EEC, 98/37/EC.
���������������
�����������������
������������
����������������
�����������������
��