Tabla de contenido
Publicidad
Technical Data
Electric hand punch
Type
Voltage
Frequency
Input
Number of lifts
Loaded
At no load
Thickness of cut sheet metal:
Steel
(400 MPa)
Steel
(600 MPa)
Steel
(800 MPa)
Aluminous
(250 MPa)
Number of regulation degrees
Cutting speed at sheet
metal thickness of 2 mm
and 400 MPa resistance
Minimum cut radius
Internal shape
External shape
Suppression level
Weight
Protection class
Attention, there is a danger of machine dam-
age in case the specified values are not met.
Controls
1. Sliding switch button
2. Gearing section
3. Engine section
4. Bonnet
5. Bonnet screw
6. Controller
7. Air vents
8. Movable supply
9. Matrix
10. Punch guide
11. Clamp bolt
12. Punch
13. Connecting hinge
14. Eccentric spindle
15. Cover ring
16. Peg
17. Beam
18. Bushing guide
19. Peg
Illustrated or described accessories need not be
included in the delivery.
��
GB
ENP 20 E
230 – 240 V
50 – 60 Hz
520 W
1450 min
–1
300 – 1950 min
–1
max. 2.0 mm
max. 1.5 mm
max. 1.0 mm
max. 2.5 mm
1–6
1.2 m/min
min. 4 mm
min. 0 mm
RO 2
2.2 kg
II /
Safety instructions
Safe work with the tools is only
possible if you read these User's
Manual thoroughly and precisely
follow the instructions hereof.
� Follow the safety instructions which are
included in each machine delivery.
� The machine must not be used in moisture or
damp spaces, outdoors when it rains, is foggy,
snows or in spaces with explosion hazard.
� If you work in a dusty place, make sure the
air vents of the tools are kept clean. If dust
needs to be removed from the tools, first
disconnect the tool from the power supply
(use non-metal objects only) and prevent the
internal parts from damage.
� Turn the machine on only with security com-
ponents in safety position.
� While cutting, do not keep your hand in front
of the punch and matrix.
� Before each using the tool, check out the
movable supply and plug. Make sure any
defects are repaired by an authorized service.
� Make sure the movable supply plug is pulled
out of the socket before any work is com-
menced on the machine.
� Out of the building, use exclusively the
approved extension cords and cable sleeves.
� Those machines that are used outdoors,
connect via a residual current device (FI) with
max 30mA operating current, Extension cord
to be used in a design for outdoors usage.
� At work, hold the machine always firmly with
both hands and ensure a safe position.
� Make sure the cut material is fixed properly.
� Always guide the machine in the cut with
power on.
� Use protective gloves, goggles and safety
boots for work.
� Always keep the direction of the movable
supply from the tools backwards.
� Do not carry the tool by the cord.
� Insert the movable supply plug in the socket
only if the machine is turned off.
� Persons under 16 are not allowed to operate
the machine.
Usage
The punch is used to cut out optional shapes
without edge distortion or deformation. It enables
cutting out boards and 360° rotation during ope-
ration.
User is liable for any unauthorized use.
Publicidad
Tabla de contenido
