Tecfrigo EXPONORM 650 P Manual De Instalacion Y Uso página 7

7. CONNECTION TO THE MAINS
1.
Ensure that mains voltage and frequency are the same as those stated on the rating plate
2.
to the appliance. Ensure that the supply socket has the following characteristics:
earthed. b) It fulfils the requirements of the rated current as set out on the rating plate.
the IEC regulations: - magnetothermal differential switch (also known as ground fault interrupter) with In
= nominal value as stated on the rating plate; - Differential with Id sensitivity = 30 mA.
there is no danger of explosion (AD) in the room.
designed for internal use. For installation in any other environments, it will be necessary to change the
cable with the appropriate type (for example H07 VVF for external use).
storage the appliance has been placed by mistake in a horizontal position or has been turned upside
down, leave for at least three hours in the correct position before switching on the power supply.
5.
Connect the plug (do not use three-way adapters and reduction adapters) (see figure 6).
8. CONTROLS
The appliance is supplied with adjusting controls situated in a protected panel on the front.
1. Refrigeration switch:
to switch on the refrigeration system.
6. Thermometer:
inside the cabinet.
the temperature in the appliance.
which can be changed by pressing button
9. CHECKING CORRECT OPERATION
CHECK THAT: 1.
The plug is connected.
thermometer shows the desired temperature for the goods to be stored.
to direct sunlight or to high-powered lamps.
appliance is designed to work normally, i.e. +30°C, 55% r.h. (climatic class 4).
10. REPLACING THE INTERNAL LIGHTS
1.
Switch off the appliance.
lamp socket from the fluorescent tube with the transparent cover.
5.
lamp socket. Remove the transparent cover.
reverse order (see figure 8).
11. REPLACING THE DOOR'S MAGNETIC GASKET
1. 2.
Open the door. Take hold of the magnetic gasket and pull it out of the frame.
gasket and press it firmly down all around (see figure 9).
Operator's guide
4.
The connecting cable to the appliance is H05 VVF
to display the temperature in the appliance.
a) 3 "SET or P"
Press button
4 "UP"
or button
2.
The refrigeration unit is switched on (green light on).
5.
The room temperature does not exceed that in which the
2.
Unscrew the screws fixing the upper lamp socket.
6.
Replace the fluorescent tube.
7
a)
N.B.
If during transport or
2. Light switch:
to switch on the light
Thermostat:
once to display the temperature set-point,
5 "DOWN"
(see figure 7).
4.
The appliance is not exposed
3.
Detach the upper
4.
Slide the tube out from the lower
7.
Refit all parts in
3.
Insert the new
(A)
attached
it is properly
c) It complies with
3.
Ensure that
,
to adjust
3.
The
I
UK
D
E
F
NL
P
S
DK
FIN
B
GR
CZ
EE
LV
LT
H
M
PL
SK
SLO