User Maintenance; Care And Servicing Of Your Andis Clipper Blades - Andis AGCB Manual De Instrucciones

REPLACING OR CHANGING BLADE SET
To replace or change your blade set, slide the blade bracket onto the hinge of the
clipper to lock into position.

USER MAINTENANCE

Cleaning and user maintenance shall not be made by
children without supervision.
The internal mechanism of your motor clipper has been permanently lubricated by
the factory. Other than the recommended maintenance described in this manual,
no other maintenance should be performed, except by Andis Company, or an Andis
authorized service station.
If the supply cord is damaged it must be replaced by the manufacturer, its service
agent or similarly qualified persons in order to avoid a hazard.
BLADE TEMPERATURE
Due to the high speed nature of Andis clippers, please check for blade heat often,
especially on close cutting blades. If blades are too hot, dip the blades only into
Andis Blade Care Plus or apply Andis Cool Care Plus and then Andis Clipper Oil.
With this detachable blade unit, you can change your blade in order to maintain a
comfortable temperature; using multiple blades of the same size is popular among
groomers.

CARE AND SERVICING OF YOUR ANDIS CLIPPER BLADES

Blades should be oiled before, during, and after each use. If your clipper blades
leave streaks or slow down, it's a sure sign blades need oil. Place a few drops of oil
on the front and side of the cutter blades (Figure M). Wipe excess oil off blades with
a soft, dry cloth. Spray lubricants contain insufficient oil for good lubrication, but are
an excellent clipper blade coolant. Always replace broken or nicked blades to prevent
injury. You can clean the excess hair from your blades by using a small brush or worn
out toothbrush. To clean the blades, we suggest to immerse the blades only into a
shallow pan of Andis Blade Care Plus, while the clipper is running. Any excess hair
and dirt that has accumulated between the blades should come out. After cleaning,
turn your clipper off and dry blades with a soft, clean, dry cloth and start clipping
again.
If upon cleaning your blades you find that the blades will still not cut, there may be a
few fine pieces of hair trapped between the upper and lower blade. If this happens,
you will need to snap the blade off the clipper. Proceed to slide the upper blade to
one side, without loosening the tension spring or moving the upper blade
completely out from under the tension spring (See Figure N for position of blade).
Wipe the surface between the blades clean with a dry cloth, then place a drop of
clipper oil where the upper and lower blades meet and also in the guide slot of the
tension spring (Figure N). Now slide the upper blade to the opposite side of the
lower blade and repeat this process. After completing this procedure, slide the upper
6