Choose The Proper Location; Install The Exhaust System - Midea MLE52S7AGS Manual Del Propietario & Instrucciones De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CHOOSE THE PROPER LOCATION

1.
Move your dryer to an appropriate location for the installation.
Consider installing the dryer and washer side-by-side, to allow access
to the gas, electrical, and exhaust connections. Place two of the carton
cushion-tops on the floor. Tip your dryer on its side so it lies across
both cushion-tops.
2.
Set your dryer back in an upright position.

INSTALL THE EXHAUST SYSTEM

1.
Review the "Exhausting Requirements" section on before installing the
exhaust system.
2.
Install the ductwork from your dryer to the exhaust hood. The crimped
end of the duct sections must point away from your dryer.
3.
DO NOT use sheet metal screws when assembling the ducting.
4.
These joints should be taped.
5.
Never use plastic flexible exhaust material.
6.
Tip for tight installations: install a section of the exhaust system onto
your dryer before putting it in place.
7.
Use duct tape to secure this section to your dryer, but do not cover the
ventilation slots at the back of the unit in dryer cabinet.
22

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Mlg52s7agsMle52s7awwMlg52s7aww

Tabla de contenido