Connect The Gas Line (For Gas Models) - Midea MLE52S7AGS Manual Del Propietario & Instrucciones De Instalación

MEASURING AND VERIFYING ACTUAL SYSTEM BACK PRESSURE
a
Dryer - empty and running on Air
Fluff cycle
b
10" (254 mm) min. of straight
pipe - measure back pressure
from the center

CONNECT THE GAS LINE (FOR GAS MODELS)

Review the "Gas Requirements" section on page 15. Remove the pipe
thread protective cap.
Apply a pipe joint compound or about 1
threaded connections.
•
The pipe joint compound must be resistant to the actions of any
liquefied petroleum gas.
Connect the gas supply to your dryer. An additional fitting is required
to connect the
3/8
the " (1 cm) male threaded end on the dryer. Use only new AGA or CSA
certified gas supply line with SS flexible connectors. within 6 ft (1.8 m) of
the dryer
Securely tighten the gas line fitting over the threads.
Turn on the gas supply.
M a n u a l
S h u t o f f
V a l v e
O p e n
24
a
3/4
" (1.9 cm) female thread end of a flexible connector to
Fl a r e
GAS FLOW
U n i o n
N i p p l e Fl e x i b l e
Co n n e c t o r
Al l c o n n e c t i o n s m u s t b e w r e n c h - t i g h t e n e d
c
b
e
c
To vent system
d
Location on back
pressure measurement
e
Inclined manometer
1/2
" wraps of teflon tape over all
Fl a r e
U n i o n
I n l e t P i p e o n
Ba c k o f Dr y e r
d