3.4.2 Address assignment for burettes when rinsing with solvents:
When rinsing with solvents by means of connected burettes (see section 4.8), one or two burettes
are connected to each measurement slot, depending on whether you are rinsing with one or two
different solvents. The following addresses have to be set for the burettes:
Address for burette
1. Measuring point
2. Measuring point
3. Measuring point
4. Measuring point
Fig. 5 Address allocation for burettes
When rinsing with solvents, only the first 4 measuring points can be supported by burettes.
Address for burette
solvent 1
9
10
11
12
solvent 2
13
14
15
0
53