Loading/Saving Methods; Evaluation: Adding/Editing Parameters - Xylem SI Analytics AVS 370 Manual De Instrucciones

4.7.3 Loading/saving methods

We recommend saving the measuring parameters a methods. The measuring parameters and
evaluation parameters will be saved in this method file. The operating parameters from "System/
Maintenance" - "Hardware" and the rinse parameters if using burettes to rinse with solvents will not be
saved. These parameters are saved at the respective measuring point. Furthermore, the selected
viscometers are also saved at the respective measuring points.
The advantage:

The method can be saved. If this is changed accidentally, it can be reloaded.

If you are working with several different methods, you can easily change these.
If you click on "Load Method" a dialog box will open where you will be able to select a new method file
(*.mdb) and open it. This method will apply to the respective measuring point only.
If you click on "Save Method as" a dialog box will open where you can save the method file under a
new name.
After saving as the new file name, this file will appear on the screen with the same measuring
parameters. The old method file will not be deleted. The system will create a copy of the old method
file and save it under the new name.

4.7.4 Evaluation: Adding/editing parameters

4.7.4.1 Select parameters
You can select or deselect pre-programmed standard parameters. Click on "Parameter Selection".
Fig. 10 Parameter-Auswahl
You can select evaluation formulas and sample parameters as parameters.
For sample parameters, an entry is required (text or number).
The preset sample parameters are:

Sample name

Concentration

Density.
The parameter kinematic viscosity must only be entered for the method "Constant", as the kinematic
viscosity is normally calculated from the running time.
61