GreenWorks Pro GPW 2300 Manual Del Operador página 23

MAINTENANCE
STORING THE PRESSURE WASHER
Store in a dry, covered area where the weather can't damage it. It is important to store this
product in a frost-free area. Always empty water from all hoses, the pump, and the detergent
container before storing.
NOTE: Use of a pump saver will give you better performance and increase the life of the
machine.
QUICK WINTERIZING PROCEDURE
You can protect your pressure washer from winter damage by doing below:
• Disconnect all water connections.
• Turn on the machine for a few seconds until the remaining water in the pump exits. Turn off
immediately.
• Do not allow high-pressure hose to become kinked.
• Store the machine and accessories in a room that does not reach freezing temperatures. Do
not store near furnace or other sources of heat as it may dry out the pump seals.
C A U T I O N
Drain gun assembly of any remaining water. Aim gun downwards and squeeze trigger.
SHUTTING DOWN AND CLEANING UP
• (If you are not using detergent, go directly to Step 2.) When you have finished using the
detergent injection system, fill detergent bottle with clean water. Siphon water at low-pressure
for one minute so that all detergent is flushed through system. Remove detergent bottle and
rinse it thoroughly.
• Disconnect the garden hose from the water inlet on the unit.
• Press trigger to release any remaining water pressure.
• Set the switch to "OFF" (O) position.
• Unplug the power cord from the outlet.
• Engage gun safety lock.
TAKING A BREAK
If taking a break of five minutes or more:
• Engage gun safety lock.
• Set unit to "OFF" (O) position.
• Unplug the power cord from the outlet.
I M P O R T A N T
The use of a pump protector is recommended when storing to help prevent a against freezing
over the winter months. It also help prevent the seals from drying out while sitting in storage in all
climates.
23