About The Crossover - Alpine iDA-X100 Manual De Instrucciones

About the Crossover

Crossover (X-OVER):
This unit is equipped with an active crossover. The crossover limits the
frequencies delivered to the outputs. Each channel is controlled
independently. Thus, each speaker pair can be driven by the frequencies
for which they have been optimally designed.
The crossover adjusts the HPF (high pass filter) or LPF (low pass filter)
of each band, and also the slope (how fast the filter rolls off the highs or
lows).
Adjustments should be made according to the reproduction
characteristics of the speakers. Depending on the speakers, a passive
network may not be necessary. If you are unsure about this point, please
consult your authorized Alpine dealer.
F/R/SUBW. Mode
Cut-off frequency
(1/3 octave steps)
HPF LPF
20 Hz -
Low range
----
speaker 200 Hz
Rear high
20 Hz -
----
range
200 Hz
speaker
Front high
20 Hz -
range ----
200 Hz
speaker
Low range
(Different from actual display)
3WAY Mode
Cut-off frequency
(1/3 octave steps)
HPF LPF
Low
20 Hz -
----
range
200 Hz
speaker
20 Hz - 20 Hz -
Mid range
speaker 200 Hz 20 kHz
1 kHz -
High
20 kHz,
range ----
(20 Hz ~
speaker
20 kHz)*
* Only when selecting User's in "Setting the Response Slope for the
High Range Speaker (Tweeter)" (page 30).
Low range Mid range High range
(Different from actual display)
Slope
Level
HPF LPF
FLAT, 6,
0 to
---- 12, 18,
-12 dB
24 dB/oct.
FLAT, 6,
0 to
12, 18, ----
-12 dB
24 dB/oct.
FLAT, 6,
0 to
12, 18, ----
-12 dB
24 dB/oct.
High range
Slope
Level
HPF LPF
FLAT, 6,
0 to
---- 12, 18,
-12 dB
24 dB/oct.
FLAT, 6, FLAT, 6,
0 to
12, 18, 12, 18,
-12 dB
24 dB/oct. 24 dB/oct.
FLAT*
0 to
6, 12, 18, ----
-12 dB
24 dB/oct.
Level adjusting
Output frequency range
(0 to -12 dB)
20 Hz
HPF cut-off LPF cut-off
frequency frequency
• HPF (high pass filter): Cuts the lower frequencies and allows the
higher frequencies to pass.
• LPF (low pass filter): Cuts the higher frequencies and allows the
lower frequencies to pass.
• Slope: The level change (in dB) for a frequency change of one octave.
• The higher the slope value, the steeper the slope becomes.
• Adjust the slope to FLAT (0 dB/oct) to bypass the HP or LP filters.
• Do not use a tweeter without the HPF on or set to a low frequency, as
it may cause damage to the speaker due to the low frequency content.
• You cannot adjust the crossover frequency higher than the HPF or
lower than the LPF.
• Adjustment should be made according to the recommended crossover
frequency of the connected speakers. Determine the recommended
crossover frequency of the speakers. Adjusting to a frequency range
outside that recommended may cause damage to the speakers.
For the recommended crossover frequencies of Alpine speakers, refer
to the respective Owner's Manual.
We are not responsible for damage or malfunction of speakers caused
by using the crossover outside the recommended value.
Slope FLAT
Slope adjusting
(Different from actual display)
35
-EN