Alpine iDA-X100 Manual De Instrucciones página 40

• Caused by the iPod Software Version not being compatible with
this unit.
- Update the iPod Software Version to be compatible with this
unit.
• The iPod is not verified.
- Reset the iPod.
- Try another iPod.
Indication for iPod Mode (Full Speed
connection)
• The iPod is not connected.
- Make sure the iPod is correctly connected (refer to
"Connections").
Make sure the cable is not bent excessively.
• There are no songs in the iPod.
- Download songs to the iPod and connect to this unit.
• Communication error
- Turn the ignition key off, and then set to ON again.
- Check the display by reconnecting between the iPod and this
unit using the FULL SPEED™ Connection Cable (KCE-422i).
• Caused by the iPod Software Version not being compatible with
this unit.
- Update the iPod Software Version to be compatible with this
unit.
38
-EN
Indication for USB memory
Current Error
• Abnormal current is run to the USB connector device (an error
message may be displayed if the USB device that is not
compatible with the unit is connected).
USB memory is a malfunction or it is shorted.
- Connect another USB memory.
USB Device Error
• A USB device that is not supported by the unit is connected.
- Connect a USB device that is supported by the unit.
TM
No USB Device
• A USB memory is not connected.
- Make sure the USB memory device is correctly connected and
the cable is not excessively bent.
• No song (file) is stored in the USB memory.
- Connect the USB memory device after storing songs (files).
• A sampling rate/bit rate not supported by the unit is used.
- Use a sampling rate/bit rate that is supported by the unit.
• A copy-protected WMA file was played back.
- You can only play back non-copy-protected files.
No Support
• Text information that is not recognizable by the unit has been
input.
- Use a USB memory device with input text information that is
supported by the unit.