Maintenance Review; Operation Of The Display/Receiver; Display General Information; Functions Of The Buttons Of The Display/Receiver - Bio Bronpi ELSA Instrucciones De Instalación, Uso Y Mantenimiento

8.9

MAINTENANCE REVIEW

It is also advisable to check and clean at least once a year, all existing ash records on the stove.
Your stove has a preventive maintenance notice, established at hours of operation, which will remind you of the
OBLIGATORY to clean the registers/records of your stove as soon as possible. In order to carry out this task, you
should contact your authorized installer.
This message is not an alarm but a reminder or warning. It will therefore allow you to use your stove while this
message is displayed, but you must seek an immediate cleaning of your stove. (see drawing D32).
Please, bear in mind that the stove could need to be cleaned before this hours established by default or even after
them. This depends on the quality of the fuel used, the smoke installation, and the proper regulation of the stove.
In the following table (also pasted on your stove in the fuel tank cover) you can check the frequency of the
maintenance tasks and who must do it.
CLEANING TASKS
Remove the burner from the chamber (on models where it can be removed) and clean the holes with the use of the
poker provided. Remove the ash with a vacuum-cleaner.
Hoover the ashes which are inside the burner place.
Operate the scrapers doing a movement from down to up several times. (**Only models provided of its)
Empty the ash pan or vacuum the ash compartment when necessary.
Vacuum the bottom of the pellet tank when necessary.
Clean the internal of the combustion chamber descale in the walls with a correct vacuum cleaner.
Clean the smoke extractor fan, the whole combustion chamber, pellet tank, whole replacement of the seals and
put again silicone where necessary, smoke duct, reservoirs...
Check all the electronic components (electronic board, display...)
Check all the electrical components (resistance, smoke extractor fan, circulator pump).
9.

OPERATION OF THE DISPLAY/RECEIVER

9.1.

DISPLAY GENERAL INFORMATION

The display shows information about the operation of the stove.
In the menu, you can find different types of options and adjust the
configuration depending on the level of access. Depending on the
operation mode, the display may take different meanings depending on
the position.
Drawing D33 describes the position of the messages during the
programming phase of the paramaters. In particular:
1. Section "D1" of the screen shows the time, the operation state,
error, menu, submenu, valued introduced.
2. Section "D2" of the screen shows the power.
3. Section "D3" of the screen shows the recipe.
4. Section "D4" of the screen shows the main temperature and the
value introduced.
9.2.

FUNCTIONS OF THE BUTTONS OF THE DISPLAY/RECEIVER

The following table shows the meaning of each key of the display as well as its function depending on the lenght when you press the key
(long or short)
KEY
P1 Views / Menu exit
P2 Modification thermostat (+) / Increase data
P3 Modify combustion power / Save data
P4 Modify thermostat (-) / Decrease data
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
P1
P3
FUNTION
SHORT
38
L1 L2
ESC
GS
L4 L5
LONG
On / Off/ Block reset
Pellet load correction
Pellet manual load
Smoke fan correction
D32
Mon 13:22
OFF
18º
22º
√ √
√ √
√ √
√ √
√ √
√ √
√ √
√ √
√ √
L3
P2
P4
W
L6 L7
D33
ELSA AND PAULA