KBL megaSun 7900 alpha Manual De Instrucciones página 36


Submenu call with START/ENTER. Displays the cur-
rent firmware version of the system components.
Do not operate the system with different
firmware versions!
•
All system components must be equipped
with

Submenu call with START/ENTER. Displays the first
and the last Software-Upload.

> 1
> 2
Only for devices with LED technology.
Colour adjustment of the LED decorative lighting.
Factory setting: 2
Submenu SERVICE MODE.
Invoked by pressing
START (ENTER).
Service mode without tanning
Service mode with tanning
36
M a n u a l d e i n s t r u c c i o n e s | megaSun 7900
SERVICE
FIRMWARE-VERSIONS
> press enter
an identical firmware
SERVICE
SOFTWARE UPLOAD
> press enter
SERVICE
RGB-Setup
>
SERVICE
SERVICE MODE
> press ENTER
SUBMENU
SERVICE MODE



04/10
Troubleshooting mode.
The service mode is switched on for 30 minutes.
The mains voltage is connected. Error notifications
are ignored, but tanning cannot be started.
version.

05/10
Troubleshooting mode.
The service mode is switched on for 10 minutes.
The mains voltage is connected. Error notifications
are ignored, tanning can be started. After this peri-
od, there is a 3 minute restart lockout.
06/10

Show the characteristics of the device:
- Configuration code
- Variant code
07/10
- Serial number

> PIN:
Branches to further configuration options.
α
lpha
SERVICE
Service mode without tanning
> Start: press `ENTER` for 2s
SERVICE
Service mode with tanning
> Start: press `ENTER` for 2s
SERVICE
SOLARIUM IDENTIFICATION
> press enter
SERVICE
SOLARIUM X-CODE
>
These settings must only be made by
trained service personnel!
01/02
02/02
08/10
09/10