Li-Ion Battery State Of Charge Display; Items Supplied; Technical Data - Hilti SBT 4-A22 Manual De Instrucciones Original

3.3 Li-ion battery state of charge display

The charge state of the Li-ion battery and malfunctions of the power tool are
indicated by the display on the Li­ion battery. The charge state of the Li­ion
battery is displayed after pressing one of the two battery release buttons.
Status
4 LEDs light.
3 LEDs light.
2 LEDs light.
1 LED lights.
1 LED blinks, the power tool is
ready for use.
1 LED blinks, the power tool is not
ready for use.
4 LEDs blink, the power tool is not
ready for use.
Battery charge state cannot be displayed while the control switch is
pressed and for up to 5 seconds after releasing the control switch. If
the battery display LEDs blink, please observe the instructions given in
the Troubleshooting section.

3.4 Items supplied

Drill / driver, operating instructions.
• Other system products approved for use with this product can be found
at your local Hilti Center or online at: www.hilti.group
4

Technical data

4.1 Drill/driver
Rated voltage
Weight including battery B22⁄8.0
Speed
Torque (soft joint)
Torque range (15 settings)
Ø drill bit (metal)
*2184702*
Meaning
State of charge: 75 % to 100 %
State of charge: 50 % to 75 %
State of charge: 25 % to 50 %
State of charge: 10 % to 25 %
State of charge: < 10 %
The battery has overheated or is
completely discharged.
The power tool is overloaded or has
overheated.
2184702
21.6 V
6.8 lb
1st gear 0 /min ...
370 /min
2nd gear 0 /min ...
2,140 /min
≤ 37 ftlb
1 ftlb
1/16 in ... 1/2 in
f
... 9 ftlb
f f
English 7