Stihl MSA 200 C Manual De Instrucciones página 75

During Operation
The green light emitting diodes glow
continuously or flash to indicate the state
of charge.
80 - 100 %
60 - 80 %
40 - 60 %
20 - 40 %
0 - 20 %
If the light emitting diodes on the battery
flash or glow red – see "If the red light
emitting diodes glow continuously /
flash".
MSA 200 C
If the red light emitting diodes glow
continuously / flash
A
B
C
D
A 1 light emitting Battery is too
1) 2)
diode glows con - hot
tinuously red:
B 4 light emitting Malfunction in
diodes flash red battery
C 3 light emitting Power tool is too
diodes glow con - hot – allow it to
tinuously red: cool down.
D 3 light emitting Malfunction in
diodes flash red power tool
1)
When charging: Charge process
starts automatically after the battery
has cooled down / warmed up.
2)
During operation: Power tool cuts
out – allow battery to cool down; it
may be necessary to take the
battery out of the power tool for this
purpose.
3)
Electromagnetic problem or fault
Defekt. Take the battery out of the
power tool and refit it. Switch on the
power tool – if the LEDs continue to
flash, the battery is faulty and must
be replaced.
4)
Electromagnetic problem or fault.
Take the battery out of the power
tool and refit it. Switch on the power
tool – if the light emitting diodes still
flash, the power tool is faulty and
must be checked by a servicing
dealer – STIHL recommends an
authorized STIHL servicing dealer.
1)
/cold
3)
4)
English
73