Bartscher 287.410 Manual De Instrucciones página 49

oven. Disconnect the electric cables, then unscrew the fixing screws (5) that hold the motor to its
support and remove the motor (4) from the support.
Ventilated electric oven electrical components (fig. 27, p. 10)
To replace the selector (4) and the thermostat (5) in the ventilated electric oven, loosen the fixing
screws (1 and 2) on the control panel (3); remove the control panel; disconnect the electrical wiring
on the component and replace the component. When the new component is in place, connect the
electrical wiring following the instructions on the wiring diagram.
Ventilated electric oven heating elements (fig. 28, p. 10)
To replace the heating elements in the ventilated oven, remove the steel rod grill, the base (1), the
upper diffuser and the grill holders. Then loosen the screws (2) holding the heating element to be
substituted (3); detach the heating element from its support on the opposite side; remove it, together
with the wiring, and disconnect it.
Electric oven electric components (fig. 29, p. 10)
To replace the selector (4) and the thermostat (3) in the electric oven, loosen the fixing screws on
the control panel (1) and the protective hood (2) and remove them. Then disconnect the electrical
wiring on the component and replace it. Then reconnect the electrical wiring following the
instructions on the wiring diagram.
Electric oven heating elements (fig. 30, p. 10)
To replace the heating elements in the oven, extract the steel rod grill, the base (1), the upper
diffuser and the grill holders. Then loosen the screws (2) holding the element to be substituted (3);
detach the heating element from its support on the opposite side; remove it, together with the
wiring, and disconnect it.
Replacing the heating element in the glass ceramic electric cooker
To replace the heating element, unscrew the control panel, loosen the screws holding the frame and
remove it. Loosen the connection wires on the heating element and remove the element, taking care
to keep the open part of the heating element upwards. Then replace the part, following the reverse
procedure.
Glass ceramic hotplate power regulator
To replace the power regulator in the glass ceramic plate, unscrew the screws holding the
instrument panel, remove it, then disconnect the electric wiring on the component and replace it.
Once replaced, reconnect the wiring according to the electrical diagram.
Pag. 48/76