SWM RS 300 R 2017 Manual - Uso - Mantenimiento página 106

HYDRAULIC CLUTCH BLEEDING
Proceed as follows:
- remove screws (1), cap (2) and rubber pump dia-
phragm;
- remove the bleeding nipple (3);
- mount a syringe in the bleeding nipple hole, then
refill with fresh fluid.
CAUTION *: NEVER use brake fluid.
- refill until fluid is discharged from the lower hole
(B) on the pump body WITHOUT BUBBLES.
The fluid level MUST NEVER BE below 4 mm from
the top (A) of the clutch pump body (see picture).
Reassemble the removed parts.
EN - 34
A
1
3
B
2