Peavey Transtube Serie Manual De Instrucciones página 33

POWER AMP SECTION
Rated Power and Load:
Power specs measured with T. Dynamics @ 100%
and Master Level @ 5
50 W RMS into 4 ohms (112)
2 x 50 W RMS into 4 ohms (212)
Power @ Clipping (typically):
(5% THD, 1 kHz, 120V AC line)
50 W RMS into 4 ohms (each amp)
Frequency Response:
+/-3 dB, 60 Hz to 20 kHz,
@ 30 W RMS into 4 ohms (each amp)
Power Amp Hum and Noise:
Greater than 75 dB below rated power
Power Consumption:
200 W (112) / 400 W (212) @ 50/60 Hz, 120 V AC, Domestic
200 W (112) / 400 W (212) @ 60 Hz, 220-230/240 V AC, Export
PREAMP/EFFECTS SECTION
D/A and A/D Conversion
Rate: 44.1 kHz
Quantization: 24 bit
The following specs are measured with the controls
set as follows:
Master Level @ 5
T. Dynamics @ 100%
Amp model set to Classic Clean
Pre, Low, Mid, and High set to 5
Post set to 10
Reverb OFF
Modulation Depth OFF
Delay Level OFF
Noise Gate disabled
Transformer
Specifications
Specifications are subject to change without notice.
System Hum and Noise
Greater than 65 dB below rated power
Effects Send(s):
Load Impedance: 1 K ohm or greater
Nominal Output Level: -10 dBV, 0.3 V RMS
Transformer 112:
Stereo output if TRS stereo plug is used.
Tip is normal signal; ring is auxiliary signal.
Transformer 212:
Mono output, tip is positive polarity.
Effects Returns:
Impedance: High-Z, 40 K ohms
Designed Input Level: -10 dBV, 0.3 V RMS
(Switching jack provides Effects Send to
Effects Return connection when not used.)
External Footswitch Functions:
Preset/Bank Selection/Display
EFX On/Off Selection/Display
Remote Tuner Access/Display
Tap Tempo of Delay with Display
(Using PFC 4 MIDI pedal, included)
Transformer 112 Dimensions:
Width: 21 3/4 inches
Depth: 14 1/4 inches
Height: 22 3/8 inches
Weight: 39.5 lbs.
Transformer 212 Dimensions:
Width:
Depth:
Height:
Weight:
33