Tornado BR Vario II Manual De Instrucciones página 10

Recommended detergents:
Application
Routine cleaning of all wa-
ter resistant floors
Routine cleaning of glossy
surfaces (e.g. granite)
Routine cleaning and basic
cleaning of industrial floors
Routine cleaning and basic
cleaning of fine stoneware
tiles
Routine cleaning of tiles in
sanitary areas
Cleaning and disinfection
in sanitary areas
Removal of coating from
all alkali-resistant floors
(e.g. PVC)
Removal of coating from li-
noleum floors
Open the cover of the fresh water reser-
voir.
Pour in water/detergent mixture. Maxi-
mum temperature of the liquid 50°C
Close the cover of the fresh water reser-
voir.
Driving to the Place of Use
Place the push handle vertically and ar-
rest.
Insert the transport wheel axles into the
borings on the appliance and lock them.
Tilt the appliance to the side and drive it
to the place of use on its transport
wheels.
At the site of use:
Press the transport wheel release but-
ton and pull the transport wheel out.
Insert the transport wheels into their
holder until they stop.
Establish mains contact
Danger
Check the mains cables of the machine
each time before using the machine to see
that it is not damaged. Never operate a ma-
chine with damaged cables. Get the dam-
aged cables replaced by an electrician.
Warning
The highest allowed net impedance at the
electrical connection point (refer to techni-
cal data) is not to be exceeded.
10
English
Detergent
RM 746
RM 780
RM 755 es
RM 69 ASF
Insert the looped end of the extension
RM 753
cable in the strain relief hook.
Plug in the mains plug.
RM 751
Move the appliance back and forth.
RM 732
Place the push handle vertically and ar-
rest.
RM 752
RM 754
Push the push handle down and turn it
to the position indicated above.
Start up the appliance (see "Cleaning")
and move it forward and backwards
over the surface to be processed.
Move the appliance from side to side
Place the push handle vertically and ar-
rest.
Push the push handle down and turn it
to the position indicated above.
Start the appliance up (see "Cleaing".
Move the appliance to the left: Press
the left side of the push handle down.
Move the appliance to the right::
Press the rlght side of the push handle
down.
Slide the lock of the push handle up and
swivel it to a comfortable working
height.
Turn on the brushes by using the switch
for the brush drive.
Turn on the brush irrigation by using the
switch for the detergent solution.
Move the appliance over the surface to
be processed by the push handle (see
"Cleaning method").
Cleaning method
Cleaning
Warning!
Risk of damage to the floor covering. Do not
operate the appliance on the spot.
Polishing
Slide the lock of the push handle up and
swivel it to a comfortable working
height.
Turn on the brushes by using the switch
for the brush drive.
Move the appliance over the surface to
be processed by the push handle (see
"Cleaning method").
Warning!
Risk of damage to the floor covering. Do not
operate the appliance on the spot.
Note
To polish underneath furniture, the fresh
water reservoir can be removed.
Shutting Down the Appliance
Release the switch for detergent solu-
tion.
Release the brush drive button.
Place the push handle vertically and ar-
rest.
Disconnect the mains plug.
Emptying the Fresh Water Reser-
voir
Lift up the fresh water reservoir and car-
ry it to the disposal site.
Warning
Please observe the local provisions regard-
ing the wastewater treatment.
Remove the cover of the fresh water
reservoir and pour out the liquid via the
notch.
Transport
If you want to transport the appliance on
a vehicle secure it from slipping.
To reduce the required space, the pushing
handle can be folded or disassembled:
Release the star grips of the pushing
handle fastening.
Unscrew the star grips, remove the
screws and take off the upper push han-
dle half.