Operating The Simplygo Device; Power Options - Philips RESPIRONICS SimplyGo Manual De Instrucciones

Operating the SimplyGo Device

Power Options

Warning: Do not use the device without the battery installed and operating�
• To run the device on battery power, make sure the battery is properly
inserted and sufficiently charged� (The battery should be fully
charged the first time you use it�)
To run the device using AC power, first make sure you have a
•
battery installed� Then, follow these steps:
1� Connect the output cable of the AC Power Supply to the
SimplyGo power input connector�
2� Connect the AC Power Cord's connector into the AC power
supply�
3� Connect the AC Power Cord's plug into an AC outlet installed to
meet national or regional electrical code�
Note: The AC Power Supply is equipped with a green light, which illuminates
when it is connected to an energized AC power source�
To run the device using DC power from an automobile or other
•
motorized vehicle, make sure the battery is installed� Start the vehicle
and connect one end of the DC Power Cord to the device's power
inlet and the other end into the vehicle's DC electrical outlet�
Because the amount of current available in the vehicle electrical
system is limited, the current available to charge the SimplyGo
battery will be determined by the operating mode of the device� At
high settings the time required to charge the battery will be much
longer and at the highest settings, it may not charge at all�
SimplyGo User Manual
13