By Motor Vehicle; By Bus Or Train - Philips RESPIRONICS SimplyGo Manual De Instrucciones

By Motor Vehicle

Use the SimplyGo DC power supply to plug in your system using the vehicle's
cigarette lighter or DC power input� Whenever the SimplyGo system is
running from a DC power source, the battery installed in your device will
begin recharging� You can also use the SimplyGo device while it is running
from a DC power source�
Caution: Make sure the vehicle has been started before plugging in your
DC power supply� If you operate the SimplyGo system using the
DC power cord while the vehicle engine is turned off, you could
inadvertently drain the vehicle's battery�
To run the device using DC power from an automobile or other motorized
vehicle, make sure the battery is installed� Start the vehicle and connect one
end of the DC Power Cord to the device's power inlet and the other end into
the vehicle's DC electrical outlet�
Because the amount of current available in the vehicle electrical system
is limited, the current available to charge the SimplyGo battery will be
determined by the operating mode of the device� At high settings the
time required to charge the battery will be much longer and at the highest
settings, it may not charge at all�

By Bus or Train

Most bus and train lines allow passengers to use portable oxygen
concentrators, but you may need to notify them in advance� When you make
your travel arrangements, contact your carrier well before your departure for
permission to bring your system and use it on board�
Note: Bus and rail carriers outside the United States may have additional
requirements for oxygen concentrators� Contact them several weeks
before you leave to identify any requirements or specifications that
may require your attention�
SimplyGo User Manual
33