Philips RESPIRONICS SimplyGo Manual De Instrucciones página 20

3� Press the Power button a second time to place the device in
operating mode� This second press helps prevent unwanted starts
or inadvertent changes in oxygen flow� The Introductory screen
momentarily appears, shown at left below, followed by the final
operating mode screen, shown at right�
Every time it starts up, the device starts producing oxygen to meet
the specified setting� It may take up to twenty minutes to reach the
specified purity levels for the setting� It is safe to begin breathing
from the SimplyGo device immediately� Breathing from the device
will cause it to reach oxygen purity levels faster�
The dot in the lower right corner of the LCD display is the pulse
symbol� It appears whenever you take a breath and the device
delivers a pulse of oxygen�
Note: When it is turned on, the device will automatically start at the flow rate
setting used when the device was last turned off. As a precaution, each
time you start the device, verify the flow setting�
4� To set the device's flow setting, press either the + or – button�
To increase the flow setting, press the + button� To decrease the flow
setting, press the – button�
The device can be set to 1, 1�5, 2, 2�5, 3, 3�5, 4, 4�5, 5, 5�5, and 6 in
Pulse or Sleep Mode� It can be set to �5, 1, 1�5, and 2 in Continuous
Flow Mode.
Warning: It is very important to set your device to your prescribed level of
oxygen flow� Do not increase or decrease your flow rate from your
prescribed level until you first consult with your physician or your
health care professional�
SimplyGo User Manual
17