General Information; Discription Of The Machine - Sima MAGNUM 700 Manual De Instrucciones

1. GENERAL INFORMATION

ATTENTION: Please read and understand perfectly the present instructions before using the machine.
SIMA S.A. thanks you for your trust in our products and for purchasing the TABLE SAW model MAGNUM.
This manual provides you with the necessary instructions to start, use, maintain and in your case, repair of
the present machine. All aspects as far as the safety and health of the users is concerned have been stated.
Respecting all instructions and recommendations assures safety and low maintenance. As such, reading this manual
carefully is compulsory for any person responsible for the use, maintenance or repair of this machine.
As such, reading this manual carefully is compulsory for any person responsible for the use, maintenance or
repair of this machine.
The Table Saws, model MAGNUM, are designed and manufactured to be used at masonry building sites to cut
porotherm blocks and other construction materials. The cutting tool is a diamond blade powered by an electric motor
and water cooled by a closed-circuit pump.
Any use other than the machine has been designed for is considered inappropriate and can be
dangerous; therefore, it is expressly prohibited.
It is recommended to have always this manual in an easily accessible place where the machine is
being used.

2. DISCRIPTION OF THE MACHINE

• The Table Saws, model MAGNUM, are designed and manufactured to be used at masonry building sites to cut
porotherm and concrete blocks but can cut also other construction materials except the adequate blade is
used. This model is manufactured of high quality materials.
• The cutting tool is a diamond blade powered by an electric motor and water cooled by a closed-circuit pump.
The moving of the blade is done manually by a transmission and a wheel, built in the cutting head.
• Thanks to its power and diameter of the blade, this machine has been designed to cut with precision
supersized materials.
• Adjusting the cutting head in height is done manually in an easy and quick way, using a lever.
• The cutting head where onto the motor is mounted remains stable when it is released. This equilibrium is
obtained by a spring, which maintains its suspension.
• The cutting head allows cutting different forms. To make longitudinal cuts, the cutting head is to be adjusted
in height and then blocked. To make vertical cuts, the cutting head is to be in a floating position.
• The chassis made of steel avoids vibrations during cutting, assuring an optimal productivity of the diamond
blades. The mono-block frame rests on four wheels, two of which are supplied with brakes to move and
station the machine with ease.
• The machine has a water tray made of galvanised steel and has a stopper to change the water and clean the
tray. All important elements that are in contact with water are made of galvanised steel.
• The machine is constructed as per the EC norms.
• The disk is rotated by means of a silent belt.
• The blade safeguard has been designed to cool the disk from both sides by the water pushed by a pump from
the tray or directly from the water tap. The water pump starts when the motor also starts.
• All the motor bearings are of high watertightness and assure a long life of its elements.
-5-
ENGLISH