Scheppach BASA3 Manual De Instrucciones página 26

Failure
Motor does not start
Motor runs forward or
backwards
No motor output turns
off automatically
Burns on the cutting
surface
Saw band clamps when
working
26 GB
Troubleshooting
Possible cause
a) Fastening nut tightened insufficiently
b) Extension cable defect
c) Connections on the motor or switch
defect
d) Motor or switch defect
Capacitor defect
a) Overload by dull saw
b) Wrong saw blade
a) Fastening nut tightened insufficiently
b) Wrong saw blade
a) Saw band blunt
a) saw band
c) Leadership poorly adjusted
Solution
a) Check the mains fuse
b) See "Electrical Connection" in the
operating
c) Have it checked by an electrician Brake
does not bleed
d) See "Electrical Connection" in the oper-
ating manual
Have it exchanged by an electrician
a) Insert a sharpened saw blade; motor can
be turned on agai
b) Select saw band according to instructions
a) Insert a sharpened saw blade
b)Select saw band according to instructions
a) Replace saw band
b) Clean saw band
c) Saw band guidance according to instruc-
tions