Odyssey 1995-1998; Odyssey 1999-2004 (Without Nav); Oasis 1996-1999 - Metra 95-7801 Instrucciones De Instalación

Honda Odyssey 1995-1998 /
Isuzu Oasis 1996-1999
1. Lower the glove box assembly. Remove (2) Phillips screws exposed on the right
side of the underdash. Remove (2) Phillips screws from the driver's side knee
bolster and (1) Phillips screw in the coin pocket. Remove (5) Phillips screws
from the underdash panel and remove the panel. Remove (4) Phillips screws
from the cup holder assembly and remove. Remove (2) Phillips screws securing
the factory radio and disconnect the wiring. (Figure A)
2. Cut and remove all mounting clips on the radio housing EXCEPT clips "D" and
"H" (Figure B, A). Cut and remove the slots on the bottom of the ISO brackets
(Figure B, B). Note: The rear support
tray will not be used in this application.
Continue to kit assembly
1
(Figure A)
Dash Disassembly
(A)
"D"
"H"
"H"
(B)
(Figure B)
95-7801
Honda Odyssey
1. Unclip the radio trim bezel (including the climate control panel) and remove.
Remove (4) Phillips screws securing the factory radio and disconnect the
wiring. (Figure A)
2. Cut and remove tabs "A" from the ISO brackets (the clips can be identified by
the stamped letter on the back of the housing, near each clip) (Figure B, A). Cut
and remove the slots on the bottom of the ISO brackets (Figure B, B).
Note: The rear support tray will not be used in this application.
Continue to kit assembly
"D"
(Figure A)
11
1999-2004
(without NAV)
"A"
(A)
(B)
(Figure B)