Accord 1998-2002; Civic 1999-2000 - Metra 95-7801 Instrucciones De Instalación

Honda Accord 1998-2002
1. Unsnap the clock panel, disconnect the wiring and remove. Remove (1) Phillips
screw exposed in the clock cavity. Remove (2) Phillips screws below the factory
radio. Unclip the radio trim bezel and disconnect the wiring. Remove (4) Phillips
screws securing the factory radio assembly and disconnect the wiring. Remove
(2) screws securing the factory pocket to the assembly. (Figure A)
2. Cut and remove tabs "B" from the ISO brackets (the clips can be identified by the
stamped letter on the back of the housing, near each clip) (Figure B, A). Cut and
remove the slots on the bottom of the ISO brackets (Figure B, B).
Note: The rear support tray will not be used in this application.
Continue to kit assembly
(Figure A)
Dash Disassembly
"B"
(A)
(B)
(Figure B)
95-7801
Honda Civic 1999-2000
1. Remove (2) Phillips screws from the bottom edge of the glove box door and
remove the door. Remove (3) Phillips screws from the lower steering column
panel. Pull straight down on the lower steering column panel and remove
the panel. Remove (2) Phillips screws under the climate controls. Remove
(4) Phillips screws from the lower dash location. Remove (4) Phillips screws
securing the bottom of the dash trim bezel/radio assembly and pull the
assembly out as far as possible. Cut the zip ties securing the radio and climate
control wires, slide dash trim bezel/radio assembly from the dash cavity and
disconnect the wiring. (Figure A)
2. Cut and remove all mounting clips on the radio housing EXCEPT clips "B" and
"H". (Figure B)
Continue to kit assembly
(Figure A)
7
"B"
"B"
"H"
"H"
(Figure B)