Tl 1996-1998; Vigor 1992-1994 - Metra 95-7801 Instrucciones De Instalación

Acura TL 1996-1998
1. Using a small screwdriver, unclip the perimeter of the radio trim bezel.
Disconnect the climate control and rear defroster wiring and remove the bezel.
Remove (4) Phillips screws securing the factory radio/trim bezel assembly.
Loosen (2) Phillips screws securing the back of the radio to the metal housing
and slide the radio out (it is NOT necessary to remove the screws securing the
metal housing to the bezel). Disconnect the wiring. (Figure A)
2. Cut and remove all mounting clips on the radio housing EXCEPT clips "B" and
"K" (Figure B, A). Cut and remove the slots on the bottom of the ISO brackets.
(Figure B, B) Note: The rear support tray will not be used in this application.
Continue to kit assembly
(Figure A)
Dash Disassembly
"B"
(A)
"B"
(B)
"K"
"K"
(Figure B)
95-7801
Acura Vigor 1992-1994
1. Remove the access cap from the climate control cluster and (1) screw exposed.
Unclip the cluster and remove (2) screws exposed. Remove the ashtray and (2)
Phillips screws exposed. Remove the cover caps from each front corner of the
center console and the screws exposed. Open the storage compartment, lift up
the carpet and remove (2) screws exposed. Lift up on the center console and
remove. Unclip the radio trim bezel and disconnect the wiring. Remove (2) bolts
from the back of the factory radio and disconnect the wiring. (Figure A)
2. Cut and remove all mounting clips
on the radio housing EXCEPT clips
"A" and "H". (Figure B)
3. Modify the factory radio housing
by trimming the shaded portions of
the housing lip. (Figure C)
Continue to kit assembly
(Figure A)
5
"A"
"A"
"H"
"H"
(Figure B)
¼" ¼"
¾"
¾"
Factory
radio
housing
1¼" 1" 1" 1¼"
opening
(Figure C)