Kit Assembly - Metra 95-7504 Instrucciones De Instalación

ISO DDIN radio provision
1. Snap the ISO DDIN brackets to the
inside edge of the radio housing.
(Figure A)
2. Slide the radio into the bracket/radio
housing assembly, and secure using
the screws supplied with the radio.
3. Snap the trim plate onto the front of
the radio housing. (Figure B)
4. Attach the (2) plastic panel clips to
the rear of the radio housing.
(Figure C)
5. Locate the factory wiring harness
and antenna connector in the
dash, and complete all necessary
connections to the radio. Metra
recommends using the proper
mating adapter from Metra and/or
AXXESS. Test the radio for proper
operation.
6. Reassemble the dash in reverse
order of disassembly.

Kit Assembly

(Figure A)
(Figure B)
(Figure C)
95-7504
3