Kit Assembly - Metra 95-7398 Instrucciones De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

KIT PREPARATION
3. Secure the factory a/c vents to the radio
trim panel using the factory hardware.
Screws have also been provided if
needed. (Figure C)
4. Secure the (3) panel clip legs to the
radio trim panel with (6) #4 screws
provided. (Figure D)
5. Attach the (5) supplied panel clips to
the panel clip legs and radio trim panel.
(Figure D)
Continue to Kit Assembly
(CONT.)
(Figure C)
(Figure D)

KIT ASSEMBLY

1. Attach the radio brackets to the radio
using screws supplied with the radio,
and then secure into the dash opening
(Figure A.
2. Locate the factory wiring harness and
antenna connector in the dash, and
complete all necessary connections to
the radio. Metra recommends using the
proper mating adapter from Metra and/
or AXXESS. Re-connect the negative
battery terminal and test the radio for
proper operation.
3. Snap the radio trim panel over the radio
and reassemble the dash in reverse
order of disassembly.
(Figure A)
REV. 1/16/2022 INST95-7398
3

Publicidad

Tabla de contenido
loading

Tabla de contenido