1. Attach the radio brackets to the radio
using screws supplied with the radio.
(Figure A)
2. Locate the factory wiring harness and
antenna connector in the dash, and
complete all necessary connections to
the radio. Metra recommends using the
proper mating adapter from Metra and/
or AXXESS. Re-connect the negative
battery terminal and test the radio for
proper operation.
3. Secure the radio to the sub-dash using
the supplied screws. (Figure B)
KIT ASSEMBLY
(Figure A)
(Figure B)
4. Prior to completing assembly, it may be
a good idea here to place the dash panel
over the radio and snap the radio trim
panel to be sure the radio does not need
adjustments. (Figure C)
5. Re-assemble the factory dash panel
then snap the radio trim panel over the
radio to complete the install.
(Figure C)
REV. 1/5/2022 INST95-5860G
3