1. Attach the radio brackets to the radio
using the screws supplied with the
radio. (Figure A)
2. Locate the factory wiring harness and
connector in the dash and complete
all necessary connections to the radio.
Metra recommends using the proper
mating adapter from Metra and/or
Axxess. Test the radio for
proper operation.
3. Slide the radio/bracket assembly into
the radio cavity in the sub dash.
(Figure B)
4. Attach the radio housing using the
factory screws. (Figure C)
5. Reassemble the dash in reverse order
of disassembly.
KIT ASSEMBLY
(Figure A)
(Figure B)
(Figure C)
3
REV. 7/14/2021 INST95-3025B