Kit Assembly - Metra 99-6520B Instrucciones De Instalación

ISO DIN radio provision with pocket
1. Secure the radio brackets to the pocket
using the (2) #8 x 3/8" Phillips screws
provided with this kit. (Figure A)
Note: Pins on the brackets will align
with the front mounting hole of pocket.
2. Remove the metal DIN sleeve and trim
ring from the aftermarket radio.
3. Slide the radio into the bracket/pocket
assembly, then secure it to the assembly
using the screws supplied with the
radio. (Figure B)
Continue to Axxess Interface Installation

KIT ASSEMBLY

(Figure A)
(Figure B)
ISO DDIN radio provision
1. Break the small locating pin from the
inside surface of each bracket.
(Figure A)
2. Secure the radio brackets to the radio
using the screws supplied with the
radio. (Figure A)
Continue to Axxess Interface Installation
Remove pin
(Figure A)
(Figure B)
REV. 4/19/22 INST99-6520B
5