6.10 Frequency Counter; Maintenance - Aim TTi TGF3162 Guia De Inicio Rapido

6.10 Frequency counter

Start with the instrument returned to Default Settings.
MENU
Utility
Parameter
Counter
Source
Type
Measurement
The Edit Box shows the current measurement. With no input signal at the selected input, the
counter displays 'No signal' until an adequate input signal is applied.
When an adequate input signal is applied, the counter constantly measures and displays the
reading in the Edit Box.

Maintenance

The Manufacturers or their agents overseas will provide a repair service for any unit developing a fault.
Where owners wish to undertake their own maintenance work, this should only be done by skilled
personnel in conjunction with the service guide which may be obtained directly from the Manufacturers or
their agents overseas.
6.10.1 Cleaning
If the instrument requires cleaning use a cloth that is only lightly dampened with water or a mild detergent.
WARNING! TO AVOID ELECTRIC SHOCK, OR DAMAGE TO THE INSTRUMENT, NEVER ALLOW
WATER TO GET INSIDE THE CASE. TO AVOID DAMAGE TO THE CASE NEVER CLEAN WITH
SOLVENTS.
HARD KEY NAME
Utility
Soft-key Name
Instr > FrCntr > On/Off
Source
Freq
Count
Setting
Counter enabled
TRIG IN - DC coupled
Frequency
25