Configurations - WEG CFW500 Guia De Instalacion

5 CONFIGURATIONS

In order to configure transfer data direction selection key,
proceed as indicated in
accessory LEDs, at the end of the transfer operation, blink
indicating the transfer status codes shawed in
Table 1: Accessory LEDs indication
Led Blinker Indication
2 x Status LED (green)
1 x Status LED (green) and
then 1 x Fault LED (red)
1 x Fault LED (red) and then 1
x Status LED (green)
Status LED (green) intermittent Transferring
2 x Fault LED (red)
3 x Fault LED (red)
For further information about the SoftPLC user's program
copy configurations, refer to the CFW500 SoftPLC
user's manual.
NOTE!
The CFW500-MMF Flash Memory Module is
able to transfer and store only two memory
areas for the parameters, as shown in the figure
below. Therefore, in order to keep the data of
user 2, you must load user 2 (P0204 = 8) before
shutting down the source inverter (Drive A),
make the data transfer with the CFW500-MMF
and, on the destination inverter (Drive B), save
user 2 (P0204 = 10).
Drive A
Actual
User 1
User 2
Figure 1: Area of data transferred by the CFW500-MMF
Flash Memory Module
figure A.1. The CFW500-MMF
Transfer Status
Parameters (Ok), SoftPLC (Ok)
Parameters (Ok), SoftPLC
(Not ok)
Parameters (Not ok), SoftPLC
(Ok)
Error: disconnected, software
version or transfer failure
Error: Low battery
CFW500-MMF
table 1.
Drive B
Actual
User 1
User 2
CFW500 | 7