Preparing The Wind Gauge And Rain Gauge And Registering On The Weather Station; Calibrating The Wind Gauge; Preparing The Rain Gauge; Automatic Wind Gauge And Rain Gauge Registration On The Weather Station - Auriol 276553 Instrucciones De Utilización Y De Seguridad

Device overview / Preparing the wind gauge and rain gauge and registering ...
Wind gauge:
Housing with built-in temperature
gauge and air humidity gauge
Transmission
Battery
signal LED compartment
Rain gauge:
Leaf filter
Battery
compartment
12. Preparing the wind gauge and
rain gauge and registering on
the weather station

12.1 Calibrating the wind gauge

The wind gauge must be recalibrated when using it
for the first time as well as every time the battery is
replaced. Follow the procedure outlined below:
– Before inserting the battery, point the vane north.
– Be sure the wind wheel and vane are not turning.
– Insert the batteries, ensuring correct polarity
(see the instructions listed under Point 10. Insert-
ing and replacing batteries / Wind gauge).
– The transmission signal LED lights up briefly.
The wind gauge is now calibrated.
32 GB/IE
North
Vane with built-in compas

12.2 Preparing the rain gauge

– Insert the batteries in the rain gauge (see the
Wind wheel
– Remove the transport protection which holds
Rain rocker
12.3 Automatic wind gauge and
After inserting batteries in the wind gauge and the
rain gauge, insert batteries in the weather station
(see the instructions listed under Point 10. Inserting
and replacing batteries / Weather station).
The weather station searches automatically for the
transmission signals from the wind gauge and rain
gauge. The process takes approx. 4 minutes.
instructions listed under Point 10. Inserting and
replacing batteries / Rain gauge).
the rain rocker.
rain gauge registration on
the weather station
MAST