Wall-Mounting The Temperature Station And/Or The Outdoor Sensor - Auriol AFT 77 B2 Manual De Instrucciones

Wall-mounting the temperature station and/or the
outdoor sensor
This step requires an electric drill, a 13/64" drill bit and a cross-head
screwdriver.
► Be careful that you do not hit electrical, gas or water lines when
drilling into the wall. Risk of injury!
► The supplied wall anchors are only suitable for fastening in concrete
or stone. It is essential that you check your installation location for
suitability for the wall anchors before installation. If in doubt, consult
a specialist.
♦ Mark the location of the hole on the wall.
♦ Using an electric drill and a 13/64" drill bit, drill the hole at the
marked point to a depth of at least 0.98 in.
♦ Push the wall anchor into the drilled hole
♦ Using a cross-head screwdriver, screw the screw into the wall anchor.
Let the screw head protrude approx. 0.12 in.
♦ Hang the temperature station or the outdoor sensor on the hooks z
or s.
AFT 77 B2
IB_345564_AFT77B2_Funk-Temperaturstation_LB9.indb 11 _345564_AFT77B2_Funk-Temperaturstation_LB9.indb 11
│
US - EN 11 ■
10.09.20 15:3 10.09.20 15:34