EGO 200/ECM01 Guía De Instalación E Información Del Usuario página 41

Optional Fitting Adapters
Additional chassis clamp adapters are available, as follows:
Low Profile Chassis Adapter Plates (Part No. CM-029)
If your chassis frame height is less than 140mm these plates must be fitted to lower
the assembly to provide the correct height of 185mm. Drilling of your chassis may be
required. Note: In some countries, the installation must be checked by a professional
technician in order to adhere to local regulations.
Narrow Gauge Chassis Adapters (Part No. CM-030)
These plates must be utilised if you have an AL-KO Vario III/AV chassis which has a
frame thickness of less than 2.8mm. These must be positioned behind the axle using
pre-drilled holes already available on the chassis; so your mover must be fitted behind
the axle.
16mm Spacers - 1 pair (Part No. CM-028)
Use spacers to lower the mover assembly if your chassis has a frame height of
between 140 to 185mm. A maximum of 3 sets of spacers can be utilised to achieve
correct frame height of 185mm. A set of extended clamp bolts must be used in
conjunction with these spacers (Part No. 346-054).
Set of 8 M10 x 100 Bolts (Part No. CM-031)
Set of 8 extended clamp bolts for use with 16mm spacers (Part No. 346-051)
Ref: EGO200/EGO400-UM-Rev.A. UK 12