Ideal 61-795 Manual De Instrucciones página 6

Resistance (Ω)/Continuity
1. Turn on the instrument.
2. Press two times to select Ω/
3. Insert test leads into the corresponding input terminals.
4. Apply test leads to de-energized circuit and press
the measurement.
5. Apply test leads:
• The ohms value is displayed.
• If <30Ω, continuity beeper also sounds.
Note: Press
LOCK
mode. LOCK is displayed and APO is defeated.
For higher accuracy and resolution:
• Press to select LoΩ (0.00 - 19.99Ω).
• Null (ZERO) test leads by touching test lead tips tightly together.
Press >2 sec. The resistance of the leads is now subtracted from
ZERO
pending measurements until
• Repeat steps 3 - 5 to take resistance measurements.
•
and to perform measurements in continuous
TEST
)
)
)
) .
)
•
)
Red
Black
is pressed again.
ZERO
6
to perform
TEST
BOILER
R
E