InPro 6000 / InTap Optical O
Unscrew and remove the spent OptoCap and the old
O-ring and replace with new ones. After this procee-
dure the senor needs to be calibrated with an air and
zero-point calibration using the correct humidity and
ambient pressure settings.
6
Disposal
It is the user's responsibility to dispose of spent spare
parts and if necessary the sensor in a professional
manner. Sensors contain electronic components that
require special disposal without any hazard for hum-
ans, and with no risk of harm to the environment.
Please observe the applicable local or national regu-
lations concerning the disposal of "waste electrical and
electronic equipment".
7
Warranty
On manufacturing defects, 12 months after delivery.
8
Storage conditions
Inspect the sensor immediately after receiving for any
transport damage. The sensor should be stored in a
dry, clean and protected area until the time of installa-
tion. If the sensor has been removed from the process,
it should be thoroughly cleaned and dried. It should
be stored in a dry, clean and protected area until time
of installation.
9
EC Declaration of Conformity
The complete declaration is available in the declara-
tion of conformity certificate.
InPro 6000 / InTap Optical O
© 06 / 2019 Mettler-Toledo GmbH.
Sensors
2
Sensors
2
25
30 313 394 B
Printed in Switzerland
en