Axxess Interface Installation - Metra 99-5834CH Instrucciones De Instalación

INTERFACE FEATURES
• Provides accessory power (12-volt 10-amp)
• Retains R.A.P. (retained accessory power)
• Provides NAV outputs (parking brake, reverse, speed sense)
• Retains audio controls on the steering wheel
®
• Retains SYNC (4.2-inch display screen models only)
• Retains the factory backup camera
• Can be used in both amplified and non-amplified models (including Sony)
• Retains balance and fade (excluding Sony)
• Micro-B USB updatable
INTERFACE COMPONENTS
• Axxess interface (built into the touchscreen display)
• 5834 harness
• HVAC interface
• HVAC interface harness
• 4-pin flat to 4-pin stacked harness
• 16-pin harness with stripped leads
• 54-pin backup camera harness
• 12-pin backup camera harness
• 4-pin harness with yellow RCA jacks
• Female 3.5mm connector with stripped leads
6

AXXESS INTERFACE INSTALLATION

TABLE OF CONTENTS
Connections
For models without a Sony amplifier ....................................................................................... 7
For models with a Sony amplifier ............................................................................................ 8
3.5mm jack - steering wheel control retention ...................................................................... 9
Backup camera harness ............................................................................................................ 9
Installation ...................................................................................................................................10
Programming ................................................................................................................................11
Extra features (SYNC)....................................................................................................................11
Touchscreen display operation ...............................................................................................12-13
Steering wheel control settings ............................................................................................ 14-15
Troubleshooting ...........................................................................................................................15
TOOLS REQUIRED
• Crimping tool and connectors, or solder gun, solder, and heat shrink
• Tape • Wire cutter • Zip ties
Attention! This interface will work with models that are either Sony amplified, or non-
amplified. Please follow the instructions carefully for your model vehicle. Failure to do
so will result in either no sound, or low sound. If you are unsure if your vehicle is factory
amplified or not, please contact your local dealership.
|
1.800.221.0932 MetraOnline.com