Kit Preparation - Metra 99-5834CH Instrucciones De Instalación

For 4.2-inch display screen models only,
®
and if SYNC is desired to be retained:
1. Remove the (4) 9/32' screws securing
®
the brackets from SYNC module.
2. Attach the SYNC ® module brackets to
the SYNC ® module using the (4)
#8 x 1/2" Phillips pan-head screws
provided. (Figure A)
3. Secure the module into the lower
sub-dash using the factory hardware
removed in step 7 of dash disassembly.
(Figure B)
4

KIT PREPARATION

(Figure A)
(Figure B)
From the factory radio/climate control panel:
1. Unclip and remove the hazard switch
and traction control buttons.
To the 99-5834CH radio trim panel:
1. Attach the hazard switch and traction
control buttons. (Figure C)
2. Attach the (7) panel clips provided.
(Figure D)
Continue to Kit Assembly
(Figure C)
(Figure D)
|
1.800.221.0932 MetraOnline.com